Reference: T1601rc
Brand: Trackmate Racing
Trackmate Iridium transponder for RC car.New version, half the size.
Reference: Iridium-m
Brand: Trackmate Racing
Compatible with the Trackmate RC lap counter. Installed in a bridge that goes across the track. Each one can cover 14.5"(36cm). Connecting cable is included.
Reference: 810
Brand: Trackmate Racing
Complete package hardware and software. Infrared RC Lap Counter / Timer for radio Controlled cars. This is everything you need to start racing on a track that is 10 feet wide.
Reference: trans-10
Brand: Trackmate Racing
SAVE 34% Transponders pack of 10 for R/C cars
Reference: TRANS-25
Brand: Trackmate Racing
SAVE 37% Transponders pack of 25 for R/C cars
Reference: trc-5
Brand: Trackmate Racing
SAVE 34% Transponders pack of 5 For R/C cars
Infrared Flood Bar assembled, A light source for sensors in the track. No alignment required. Select the length you need.
Select the length you need. Build your own bridge and mount the flood bar strip underneath it. No soldering required. 6 foot wire included. the height of the bridge should be 3 to 4 inches. requires 12 volts. Can be powered by the new blue box lap counting interface. The length you need is the distance from the first slot to the last slot.
Reference: ac232
USB to serial. Required if your computer does not have a 9 pin serial port and only has USB ports. New computers will most likely require the USB to serial.
Reference: SCL-R
Brand: Trackmate Racing
Discontinued.Replacement module for Trackmate Lap Counter. Click details to see power adapter options.
Reference: SCLW
Wireless track call button, will require to solder 2 wires to the Tackmate interface, instructions included. Works up to 60 feet!
Reference: SC106
Brand: Trackmate Racing
For 6 lanes. Makes connecting to relay very easy, 2 terminal screws for each lane. Two terminal screws for relay coil.
Reference: IRSENSORS
Brand: Trackmate Racing
5 infrared sensors 3mm, includes heat shrink. Keep spares
Four Infrared LEDs. These LEDs are extremely good. Good range and uniform cover. Perfect alignment is not required. Also check out our complete LED kit with adapter.
Reference: flood8xx
Brand: Trackmate Racing
https://youtu.be/7NRAQ25uLaI?si=04Kl-lH8VNNlePq4&t=146Infrared Flood Bar, No alignment with sensors required. Select length required 12 Volt adapter included.
Reference: SC104
Brand: Trackmate Racing
Makes connecting to relay very easy, 2 terminal screws for each lane. Two terminal screws for relay coil.
Reference: RLY12V30
Brand: Trackmate Racing
Relay to control track power. Also see our Mini relay panel for super easy connections.
Reference: SCLC-unit
Replacement unit only. Slot car lap counter with time sell, to sell time per lane.Does NOT include Relay board, sensor cable, track call buttons
Reference: 12v500ma
12 volt adapter. 500ma. For Slot car interface. Replaces older 9 volt adapters that were used in the past.Also used on LED Bridge/Gantries.
Reference: CBL-9EXT-30
Brand: Trackmate Racing
Serial Cable. Long serial cables allow computer to be far away from the track. Can be used with Red or Green Trackmate SCL slot car interface, DP3000, DP2000.
Recommended only for tracks that use four stock power packs. This relay has a set of contacts for each power pack.
Reference: Jumbo
Track call button. Start and pause race. Normally uses with the relay option. Connect one or many.
Adapter to use existing 25 pin sensor cable with the newer Trackmate black Interface SCL3-USB with RJ45 8 pin connector. Will only work with 1 to 4 lane cables.
Infrared Flood Bar assembled, A light source for sensors in the track. No alignment required. Select the length you need.
