Reference: T1601rc
Brand: Trackmate Racing
Trackmate Iridium transponder for RC car.New version, half the size.
Reference: Iridium-m
Brand: Trackmate Racing
Compatible with the Trackmate RC lap counter. Installed in a bridge that goes across the track. Each one can cover 14.5"(36cm). Connecting cable is included.
Reference: 810
Brand: Trackmate Racing
Complete package hardware and software. Infrared RC Lap Counter / Timer for radio Controlled cars. This is everything you need to start racing on a track that is 10 feet wide.
Reference: trans-10
Brand: Trackmate Racing
SAVE 34% Transponders pack of 10 for R/C cars
Reference: TRANS-25
Brand: Trackmate Racing
SAVE 37% Transponders pack of 25 for R/C cars
Reference: trc-5
Brand: Trackmate Racing
SAVE 34% Transponders pack of 5 For R/C cars
Substitute module for the Trackmate SCL81 USB Lap/Timer Counter, originally designed in 2014. Features integrated USB functionality, eliminating the need for a USB to serial adapter. Capable of supporting 8 lanes and compatible with 8-pin sensor cables.
Supports 1 to 8 lane,
Requires 8 pin RJ45 sensor cables.
Not compatible with sensors cables with 25 pin connector.
Reference: SCLW
Wireless track call button, will require to solder 2 wires to the Tackmate interface, instructions included. Works up to 60 feet!
Reference: 12v1600n
12 volt adapter rated to 1.6 amps. Used on Sell time units with 4 to 8 relays. Required if you want to power more than 3 relays on a Trackmate interface.
Reference: flood850n
Brand: Trackmate Racing
Infrared Flood Bar assembled, A light source for sensors in the track. No alignment required. Select the length you need.
Reference: IRSENSORS
Brand: Trackmate Racing
5 infrared sensors 3mm, includes heat shrink. Keep spares
Reference: CBL-s
Brand: Trackmate Racing
Sensor Cable with 8 pin connector (RJ45). For new black Trackmate interface SCL3-USB. Available in Infrared, Dead Strip and Reed type. Click view then select cable type.
Four Infrared LEDs. These LEDs are extremely good. Good range and uniform cover. Perfect alignment is not required. Also check out our complete LED kit with adapter.
Reference: SCL3
Brand: Trackmate Racing
Replacement module for Trackmate SCL45 USB Lap Counter. Designed in 2022. Integrated USB, no USB to serial required. Compatible with RJ45 sensor cables. Supports 4 lanes and 4 relays.
Reference: CBL-9EXT-30
Brand: Trackmate Racing
Serial Cable. Long serial cables allow computer to be far away from the track. Can be used with Red or Green Trackmate SCL slot car interface, DP3000, DP2000.
Reference: flood8xx
Brand: Trackmate Racing
https://youtu.be/7NRAQ25uLaI?si=04Kl-lH8VNNlePq4&t=146Infrared Flood Bar, No alignment with sensors required. Select length required 12 Volt adapter included.
Reference: Reed-4
Brand: Trackmate Racing
Four Reed switches for $14, Including heat shrink, Keep spares. Normally used with HO slot car lap counters.
Reference: 12v500ma
12 volt adapter. 500ma. For Slot car interface. Replaces older 9 volt adapters that were used in the past.Also used on LED Bridge/Gantries.
Reference: SC106
Brand: Trackmate Racing
For 6 lanes. Makes connecting to relay very easy, 2 terminal screws for each lane. Two terminal screws for relay coil.
Reference: SC104
Brand: Trackmate Racing
Makes connecting to relay very easy, 2 terminal screws for each lane. Two terminal screws for relay coil.
Save dollars on your Slot car lap counter. This is a Do It Yourself version of the prewired LED kit. All the parts included to make an overhead light source for an infrared lap counter. Includes instructions, power adapter, LEDs, heat shrink, Connector and wire.
Reference: GANTRY
Brand: Trackmate Racing
Gantry (Bridge) Uses infrared LEDs for light source. Recommended when using infrared sensors for lap counter . Includes DC adapter. Wires can go through table and be completely hidden. (Track not included). Click view and select type
Substitute module for the Trackmate SCL81 USB Lap/Timer Counter, originally designed in 2014. Features integrated USB functionality, eliminating the need for a USB to serial adapter. Capable of supporting 8 lanes and compatible with 8-pin sensor cables.
