Reference: T1601rc
Brand: Trackmate Racing
Trackmate Iridium transponder for RC car.New version, half the size.
Reference: Iridium-m
Brand: Trackmate Racing
Compatible with the Trackmate RC lap counter. Installed in a bridge that goes across the track. Each one can cover 14.5"(36cm). Connecting cable is included.
Reference: 810
Brand: Trackmate Racing
Complete package hardware and software. Infrared RC Lap Counter / Timer for radio Controlled cars. This is everything you need to start racing on a track that is 10 feet wide.
Reference: trans-10
Brand: Trackmate Racing
SAVE 34% Transponders pack of 10 for R/C cars
Reference: TRANS-25
Brand: Trackmate Racing
SAVE 37% Transponders pack of 25 for R/C cars
Reference: trc-5
Brand: Trackmate Racing
SAVE 34% Transponders pack of 5 For R/C cars
5 infrared sensors 3mm, includes heat shrink.
Keep spares
Use in Trackmate slot car timers
Size: 3mm
Long lead to white stripe wire
Short lead to solid color wire.
Reference: 12v500ma
12 volt adapter. 500ma. For Slot car interface. Replaces older 9 volt adapters that were used in the past.Also used on LED Bridge/Gantries.
Reference: SCL3
Brand: Trackmate Racing
Substitute module for the Trackmate SCL81 USB Lap/Timer Counter, originally designed in 2014. Features integrated USB functionality, eliminating the need for a USB to serial adapter. Capable of supporting 8 lanes and compatible with 8-pin sensor cables.
Reference: usbab-15
USB cable Type AB for Trackmate interface SCL3usb. 15ft long. This is longest USB cable you can use.
Reference: RLY12V30
Brand: Trackmate Racing
Relay to control track power. Also see our Mini relay panel for super easy connections.
Reference: ac232
USB to serial. Required if your computer does not have a 9 pin serial port and only has USB ports. New computers will most likely require the USB to serial.
Reference: SCLC-unit
Replacement unit only. Slot car lap counter with time sell, to sell time per lane.Does NOT include Relay board, sensor cable, track call buttons
Reference: CBL-9EXT-30
Brand: Trackmate Racing
Serial Cable. Long serial cables allow computer to be far away from the track. Can be used with Red or Green Trackmate SCL slot car interface, DP3000, DP2000.
Recommended only for tracks that use four stock power packs. This relay has a set of contacts for each power pack.
Reference: CBL-s
Brand: Trackmate Racing
Sensor Cable with 8 pin connector (RJ45). For new black Trackmate interface SCL3-USB. Available in Infrared, Dead Strip and Reed type. Click view then select cable type.
Save dollars on your Slot car lap counter. This is a Do It Yourself version of the prewired LED kit. All the parts included to make an overhead light source for an infrared lap counter. Includes instructions, power adapter, LEDs, heat shrink, Connector and wire.
Reference: 12v1600n
12 volt adapter rated to 1.6 amps. Used on Sell time units with 4 to 8 relays. Required if you want to power more than 3 relays on a Trackmate interface.
Adapter to use existing 25 pin sensor cable with the newer Trackmate black Interface SCL3-USB with RJ45 8 pin connector. Will only work with 1 to 4 lane cables.
Reference: SC104
Brand: Trackmate Racing
Makes connecting to relay very easy, 2 terminal screws for each lane. Two terminal screws for relay coil.
Reference: SCL3
Brand: Trackmate Racing
Replacement module for Trackmate SCL45 USB Lap Counter. Designed in 2022. Integrated USB, no USB to serial required. Compatible with RJ45 sensor cables. Supports 4 lanes and 4 relays.
Reference: GANTRY
Brand: Trackmate Racing
Gantry (Bridge) Uses infrared LEDs for light source. Recommended when using infrared sensors for lap counter . Includes DC adapter. Wires can go through table and be completely hidden. (Track not included). Click view and select type
Reference: flood850n
Brand: Trackmate Racing
Infrared Flood Bar assembled, A light source for sensors in the track. No alignment required. Select the length you need.
5 infrared sensors 3mm, includes heat shrink.
Keep spares
