Reference: T1601rc
Brand: Trackmate Racing
Trackmate Iridium transponder for RC car.New version, half the size.
Reference: Iridium-m
Brand: Trackmate Racing
Compatible with the Trackmate RC lap counter. Installed in a bridge that goes across the track. Each one can cover 14.5"(36cm). Connecting cable is included.
Reference: 810
Brand: Trackmate Racing
Complete package hardware and software. Infrared RC Lap Counter / Timer for radio Controlled cars. This is everything you need to start racing on a track that is 10 feet wide.
Reference: trans-10
Brand: Trackmate Racing
SAVE 34% Transponders pack of 10 for R/C cars
Reference: TRANS-25
Brand: Trackmate Racing
SAVE 37% Transponders pack of 25 for R/C cars
Reference: trc-5
Brand: Trackmate Racing
SAVE 34% Transponders pack of 5 For R/C cars
https://youtu.be/7NRAQ25uLaI?si=04Kl-lH8VNNlePq4&t=146Infrared Flood Bar, No alignment with sensors required. Select length required 12 Volt adapter included.
The flood bar creates a light source for the sensors mounted in the track. When the slot car goes over the sensor it will trigger a lap.
Use this flood if you can not use any of our premade bridges for your custom track.
No aligment is required with sensors in the track. You will need to make your own structure to support it, the height should be around 3 to 4 inches high.
The length required is the distance from the first slot to the last slot. For example if you have a 3 Lane track with 3.25 spacing you only need a 6.5 inch flood bar or next size up.
Youtube Video from customer
Reference: SCL3C-usb
Brand: Trackmate Racing
If you are looking for a Dead strip or Reed switch solution this is the kit you need, Or if you want to do infrared but can't use any of the bridges available in the other kits. Includes Interface New SCL3-USB with USB integrated 10 foot USB Cable 5 foot Sensor Cable Relay Jumbo Switch Please select number of lanes and sensor type
Recommended only for tracks that use four stock power packs. This relay has a set of contacts for each power pack.
Reference: 12v500ma
12 volt adapter. 500ma. For Slot car interface. Replaces older 9 volt adapters that were used in the past.Also used on LED Bridge/Gantries.
Reference: SCL3
Brand: Trackmate Racing
Replacement module for Trackmate SCL45 USB Lap Counter. Designed in 2022. Integrated USB, no USB to serial required. Compatible with RJ45 sensor cables. Supports 4 lanes and 4 relays.
Reference: SCLC-unit
Replacement unit only. Slot car lap counter with time sell, to sell time per lane.Does NOT include Relay board, sensor cable, track call buttons
Reference: GANTRY
Brand: Trackmate Racing
Gantry (Bridge) Uses infrared LEDs for light source. Recommended when using infrared sensors for lap counter . Includes DC adapter. Wires can go through table and be completely hidden. (Track not included). Click view and select type
Reference: SCLW
Wireless track call button, will require to solder 2 wires to the Tackmate interface, instructions included. Works up to 60 feet!
Reference: 12v1600n
12 volt adapter rated to 1.6 amps. Used on Sell time units with 4 to 8 relays. Required if you want to power more than 3 relays on a Trackmate interface.
Reference: Jumbo
Track call button. Start and pause race. Normally uses with the relay option. Connect one or many.
Reference: SC106
Brand: Trackmate Racing
For 6 lanes. Makes connecting to relay very easy, 2 terminal screws for each lane. Two terminal screws for relay coil.
Reference: ac232
USB to serial. Required if your computer does not have a 9 pin serial port and only has USB ports. New computers will most likely require the USB to serial.
Adapter to use existing 25 pin sensor cable with the newer Trackmate black Interface SCL3-USB with RJ45 8 pin connector. Will only work with 1 to 4 lane cables.
Reference: CBL-9EXT-30
Brand: Trackmate Racing
Serial Cable. Long serial cables allow computer to be far away from the track. Can be used with Red or Green Trackmate SCL slot car interface, DP3000, DP2000.
Reference: Reed-4
Brand: Trackmate Racing
Four Reed switches for $14, Including heat shrink, Keep spares. Normally used with HO slot car lap counters.
Reference: SCL3
Brand: Trackmate Racing
Substitute module for the Trackmate SCL81 USB Lap/Timer Counter, originally designed in 2014. Features integrated USB functionality, eliminating the need for a USB to serial adapter. Capable of supporting 8 lanes and compatible with 8-pin sensor cables.
Four Infrared LEDs. These LEDs are extremely good. Good range and uniform cover. Perfect alignment is not required. Also check out our complete LED kit with adapter.
https://youtu.be/7NRAQ25uLaI?si=04Kl-lH8VNNlePq4&t=146Infrared Flood Bar, No alignment with sensors required. Select length required 12 Volt adapter included.
