DIY INFRARED LED KIT

Reference: Sens-4

Infrared Sensors Set of 4 with heat shrink

Infrared Sensors,

Reference: TM104

Brand: Trackmate Racing

Driver Station in box

This is a driver station also called a controller hook up panel.  Accepts banana plugs or aligator clips.   10 amp Direction switch.  Compatible with electronic controllers.   LED indicators.

Reference: RLY8

Slot Car Track Relay Panel With 8 Relays

The perfect relay panel for 1:24 scale commercial tracks that run on batteries or 50 amp to 95 amp power supplies.  Relay panel comes with 8 relays and master relay.  Can be easily connected to Trackmate interface. 

Reference: 12v500ma

12v adapter

12 volt adapter. 500ma.  For Slot car interface.  Replaces older 9 volt adapters that were used in the past.Also used on LED Bridge/Gantries.  

Reference: 12v1600n

12v adapter 1.6 amps

12 volt adapter rated to  1.6 amps.  Used on Sell time units with 4 to 8 relays.    Required if you want to power more than 3 relays on a Trackmate interface.  

12v volt Power Adapter

12 volt 500ma replacement power pack/ adapter  RC lap counter, Slot car lap counter, Drag_Pro2000/3000  

Reference: CBL-9EXT-30

Brand: Trackmate Racing

Serial Cable - Select Length

Serial Cable.   Long serial cables allow computer to be far away from the track. Can be used  with Red or Green Trackmate SCL slot car interface, DP3000, DP2000.

Reference: flood850n

Brand: Trackmate Racing

Infrared flood bar

Infrared Flood Bar assembled,  A light source for sensors in the track.  No alignment required.   Covers 8.5 inches wide. Connect 12 volts to it. Power adapter not included.      

Reference: Reed-4

Brand: Trackmate Racing

Reed Switches

Four Reed switches for $14, Including heat shrink, Keep spares.  Normally used with HO slot car lap counters.

Reference: ac232

USB to serial

USB to serial.  Required if your computer does not have a 9 pin serial port and only has USB ports.  New computers will most likely require the USB to serial.

Reference: V102

Brand: Trackmate Racing

Video Splitter 2 monitors

Electronic Video Splitter, Does not degrade video quality, Add a second monitor to the PC, so all racers can view race results. Includes 6' VGA cable to plug splitter into PC

Reference: PD6

Brand: Trackmate Racing

Track Power Tap Distribution Box

High quality power distribution box,  no soldering or crimping required. Simply strip 3/16 inch from wire end and insert and screw down.  One input and 6 power tap outputs.  One required per lane.  Board can be removed and then box can be securely screwed down for easy mounting.

Reference: TM104-BLK

Brand: Trackmate Racing

Driver Station in box - 6 Colors

This is a driver station also called a controller hook up panel.  Accepts banana plugs or aligator clips.   10 amp Direction switch.  Compatible with electronic controllers.   LED indicators. *** NOW IN COLOR

Reference: SC104

Brand: Trackmate Racing

Mini Relay Panel - 4 Lane

Makes connecting to relay very easy, 2 terminal screws for each lane. Two terminal screws for relay coil.

Reference: ban3

Set of banana plugs, white. black, red

3 banana plugs in white, black and red colors.   Solder to controller wires

2 conductor 18 gauge wire 100 feet

2 conductor 18 gauge wire 100 feet  red and black,  Ideal for wiring HO or 1:32 scale tracks.